Zenith DXG-210 Instruction Manual

TheaterLite™DXG-210operating guide

1918196.2.4 Zap menuZap menuThe Zap menu is used to assign functions tothe zap keys on the remote control. The menuconsists of two columns of buttons

2120All options will be available when NTSC videois connected. Select OK to save your changes and exit, orselect Cancel to exit without saving yourcha

23No image appears on the screenPossible causes and remedies:1. The projector is left in Standby mode. Ifthe product is in standby mode, there willbe

24206-03704© Copyright 2001 Zenith Electronics Corporation

3WARNING:TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFERSERVICING TO QUALIFIED SERVICE PER

54(Continued from previous page)14. Outdoor Antenna GroundingIf an outside antenna or cable system is connected to theproduct, be sure the antenna or

PageUsing the menus . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .156.1 The Menu System . . . . . . . . . . . . . . . . . . .

1.3 Insert batteries in theremote control Figure 5 shows the remote control with thebattery lid removed. Slide off the battery lidand insert the batte

The procedure for connectinga video source to the projec-tor is the same for S-Videoand Composite video.SECAM, PAL N and PAL M modes are manuallyselec

The Remote control is very easy to operate. Ithas only six keys in addition to the pressuresensing mouse pad. The six keys are:Key underneath the cont

5.4 Adjusting the height andangle of the projectorYou can adjust the height and angle of theprojector by adjusting the four small feetunderneath the p

1716 176.2 Set-up menuSet-up menuIn the set-up menu the following sub-menus are available:• Picture orientation• Language• Quick key assignment• ZAP k