Zenith 9820CH Instruction Manual Page 1

Pg 1 of 14Before You BeginThank you for purchasing this prod-uct. We’ve included easy to followstep-by-step instructions which havebeen carefully writ

66top assemblyensamble superior Unité supérieurebottom assemblyensamble inferiorUnité inférieureCarefully place top assembly on bottomassembly. NOTE:

Pg 11 of 14Fasten hinges (H) to doors (5). Asegure las bisagras (H) a las puertas (5). Fixez les charnières (H) aux portes (5).12.Insert 2 snap cams (

Attach door knobs (J) to doors (5). Asegure las perillas para puertas (J) a laspuertas (5).Fixez les boutons de portes (J) aux portes(5).14.Fasten hin

Pg 13 of 1416.5Place magnet strikes (M) on magnet (F) andpeel off adhesive back. Close doors (5) andapply slight pressure. Coloque las contrachapas pa

Pg 14 of 1417.Top of the unitParte superior de la unidad Haut du meubleNot IncludedNo IncluidoNon inclusePNOMounting Instructions: It is imperative th

Pg 2 of 14(A) 28 Large Screws28 Tornillos grands28 vis longues(C) 2 Cambolts2 Pernos para levas2 boulons à cames(N) 1 Nylon Strap1 Tira de Nylon1 band

Cleaning Note: Cleaning with adry cloth may be sufficient, but forother stains or marks wipe gentlywith a damp cloth. DO NOT usestrong detergents or a

1.Fasten 2 support rails (4) to bottom sidepanels (6). This is the bottom assembly.Asegure 2 rieles de soporte (4) a los paneleslaterales inferiores (

Place the bottom assembly in desired loca-tion. Then install bottom support rail (4) withfinished edge facing up. NOTE: The bottomsupport rail (4) may

Pg 6 of 14Fasten the magnet (F) to top panel (1). Asegure el magneto (F) al panel superior(1). Fixez l'aimant (F) au panneau supérieur (1).3.14.

5.Attach the other top side panel (3) to the toppanel (1).Fije el otro panel lateral superior (3) al panelsuperior (1).Fixez l'autre panneau laté

Attach the bottom shelf (1) to the top sidepanels (3). NOTE: Make sure the side of thebottom shelf (1) with the most holes is facingaway from the top

Pg 9 of 14Lay unit face down on floor. Fasten backpanel (7) to back of unit. NOTE: Make surefinished side of back panel (7) is facingdown. This is the